Allied Telesis AT-GS908M User Manual

AT-GS900M Series CLI Reference
Section II: Switch Management 111
Chapter 7
SNMP Commands
The SNMPv1 and SNMPv2c commands are summarized in Table 13.
Table 13. SNMPv1 and SNMPv2 Commands
Command Description
“ADD SNMP COMMUNITY” on
page 113
Changes the settings of the traphost,
manager, trap parameters for an SNMP
community.
“CREATE SNMP COMMUNITY”
on page 115
Creates a new SNMP community.
“DELETE SNMP COMMUNITY”
on page 118
Removes the specified settings of the
SNMP community.
“DESTROY SNMP COMMUNITY”
on page 119
Deletes the specified SNMP community.
“DISABLE INTERFACE
LINKTRAP” on page 120
Disables generating SNMP traps when
the link is up or down at the specified port
interface.
“DISABLE SNMP” on page 121 Disables SNMP.
“DISABLE SNMP COMMUNITY”
on page 122
Disables the specified SNMP community.
“DISABLE SNMP COMMUNITY
TRAP” on page 123
Disables sending SNMP traps to the
specified community.
“DISABLE SNMP TRAP” on
page 124
Disables generating SNMP traps.
“ENABLE INTERFACE
LINKTRAP” on page 125
Enables generating SNMP traps when
the link is up or down at the specified port
interface.
“ENABLE SNMP” on page 126 Enables SNMP.
“ENBLE SNMP COMMUNITY” on
page 127
Enables the specified SNMP community.
“ENABLE SNMP COMMUNITY
TRAP” on page 128
Enables sending SNMP traps to the
specified community.

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English