Allied Telesis AT-GS908M - Show Qos Scheduling

Chapter 25: Quality of Service (QoS) Commands
454 Section IV: Security and Traffic Control
SHOW QOS SCHEDULING
Syntax
show qos scheduling
Parameters
None
Description
Use this command to display the settings of QoS scheduling on the switch.
An example of the command output is shown in Figure 70.
Figure 70. SHOW QOS SCHEDULING Command
Example
The following example displays the settings of QoS scheduling on the
switch:
Manager > show qos scheduling
QoS Scheduling Mode
----------------------------------------------------
Mode ...................... 802.1p
Scheduling ................ Weighted Round-Robin
----------------------------------------------------