Chapter 27: Port-Based Authentication Commands
526 Section IV: Security and Traffic Control
vlanassignmenttype
Specifies that Dynamic VLAN is set based on ports or users (MAC
addresses). This parameter is effective when the mode is multi and
vlanassignment is enabled. The default setting is port.
Description
Use this command to change the authenticator port settings for MAC
address-based and Web-based authentication on the specified port.
Here are references for other usage of this command:
To change the authenticator port settings for all authentication
methods including 802.1x Port-based, MAC address-based, and
Web-based authentication on the specified port, see “SET
PORTAUTH PORT (Authenticator Port for All Methods)” on
page 514.
To change the authenticator port settings for 802.1x Port-based
authentication on the specified port, see “SET PORTAUTH PORT
(802.1X Authenticator Port)” on page 518.
To change the supplicant port settings for 802.1x Port-based
authentication on the specified port, see “SET PORTAUTH PORT
(802.1X Supplicant Port)” on page 522.
To cancel the port as an authenticator and supplicant. on the
specified port, see “SET PORTAUTH PORT (Canceling the
Authentication Type)” on page 527.
Confirmation Commands
“SHOW PORTAUTH” on page 532
“SHOW VLAN” on page 216
Example
The following command changes the mode for MAC address-based and
Web-based authentication in the authenticator port type on port 1 to 8:
Manager > set portauth=webbased port=1-8 type=authenticator
mode=single
To Next Page
Loading...
Need help?
General
