AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 523
Description
Use this command to change the supplicant port settings for 802.1x Port-
based authentication on the specified port.
Here are references for other usage of this command:
To change the authenticator port settings for all authentication
methods including 802.1x Port-based, MAC address-based, and
Web-based authentication on the specified port, see “SET
PORTAUTH PORT (Authenticator Port for All Methods)” on
page 514.
To change the authenticator port settings for 802.1x Port-based
authentication on the specified port, see “SET PORTAUTH PORT
(802.1X Authenticator Port)” on page 518.
To change the authenticator port settings for MAC address-based
and Web-based authentication on the specified port, see “SET
PORTAUTH PORT (Authenticator Port for MAC and Web)” on
page 524.
To cancel the port as an authenticator and supplicant. on the
specified port, see “SET PORTAUTH PORT (Canceling the
Authentication Type)” on page 527.
Confirmation Commands
“SHOW PORTAUTH” on page 532
Example
The following command changes the EAPOL version for the 802.1x
authentication in the authenticator port type on port 1 to 8:
Manager > set portauth=8021x port=1-8 type=supplicant
username=user1 password=secret
To Next Page
Loading...
