AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 225
the same trunk group.
A Loop Detection enabled port and a Loop Detection disabled port
cannot belong to the same trunk group.
A port that is set the security mode cannot be a trunk member.
MDI/MDI-X automatic detection cannot be enabled on a trunk
member port.
Port 9 on the GS908M V2 switch cannot be a trunk member.
The 100M SFP port cannot be a trunk member.
Broadcast, multicast, and unlearned unicast frames are sent from
the master port.
Confirmation Command
“SHOW SWITCH TRUNK” on page 278
Example
The following command creates a new trunk group of uplink:
Manager > create switch trunk=uplink
To Next Page
Loading...
Need help?
General
