Chapter 19: Power Saving Commands
348 Section III: Layer 2 Switching
Description
Use this command to create a power saving trigger.
Here are the guidelines for power saving triggers:
To start the switch in the sleep mode due to the trigger, you must
power on the switch or press the reset button.
To start the switch in the sleep mode right after the trigger starts,
you must wait at least one minute to restart the switch.
A log messages is issued when the trigger ends and the switch is
released from the sleep mode.
The maximum days is 28 days for a trigger with the sleep mode.
You must power on or reset the switch to be released from the
sleep mode if the days parameter is set to longer than 28 days.
When the trigger effective time is less than 3 minutes, the switch
does not stop supplying power to PoE devices even if the psmode
is set to poeoff.
Confirmation Command
“SHOW TRIGGER” on page 360
Example
The following command creates a trigger to set the switch in the sleep
mode starting at 23:00 and ending at 6:00:
Manager > create trigger=1 psmode=sleep startime=23:00
endtime=6:00
To Next Page
Loading...
