Allied Telesis AT-GS908M - Page 367

AT-FS900M Series CLI ReferenceAT-GS900M Series CLI Reference
Section III: Layer 2 Switching 367
Examples
The following command sets the bridge priority to 20480, the hello time to
5 seconds, and the forwarding delay to 20 seconds:
set stp priority=20480 hellotime=5 forwarddelay=20
The following command uses the RSTPTYPE parameter to configure the
bridge to use the RSTP parameters but to transmit only STP BPDU
packets:
set stp rstptype=stpcompatible
The following command returns all RSTP parameter settings to their
default values:
set stp default
Equivalent Command
purge stp
For information, see “PURGE STP” on page 364.