Chapter 26: Policy-Based QoS Commands
464 Section IV: Security and Traffic Control
moveprioritytotos
Specifies yes, no, or none to the state that the priority is used for
the ToS value. The default setting is none.
classifier_list
Specifies a list of classifiers. To specify multiple classifiers, use a
comma (,) to separate them. To specify a range of classifiers, use
a hyphen (-). The default setting is none.
Description
Use this command to create a flow group. You can assign flow groups to
the traffic group to define more detailed traffic. The flow group consists of
classifiers.
Here are the guidelines for creating a flow group:
The markvalue parameter of the flow group has higher priority over
the makrvalue parameter of the traffic class and indscpoverwrite
parameter of the policy.
The markvalue and tos parameters cannot be used concurrently.
The markvalue and moveprioritytotos parameters cannot be used
concurrently.
The tos and moveprioritytotos parameters cannot be used
concurrently.
Confirmation Command
“SHOW QOS FLOWGROUP” on page 493
Example
The following command creates flow group 1:
Manager > create qos flowgroup=1
To Next Page
Loading...
Need help?
General
