Allied Telesis AT-GS908M - Page 492

Chapter 26: Policy-Based QoS Commands
492 Section IV: Security and Traffic Control
Figure 71. SHOW CLASSIFIER Command
Example
The following example displays the settings of classifier 2:
Manager > show classifier=2
Manager > show classifier
---------------------------------------------
Classifier ID: .................. 1
TCP Dst Port: ................... 80
Number of References: ........... 1
Number of Active Associations: .. 0
Manager > show classifier=2
---------------------------------------------
Classifier ID: .................. 2
Description: .................... atkk-ud1
Eth Format: ..................... 802.2-Tagged
Priority: ....................... 7
Protocol: ....................... 0x806 (ARP)
Number of References: ........... 0
Number of Active Associations: .. 0
Manager > show classifier ethformat=802.2-untagged
---------------------------------------------
Classifier ID: .................. 3
Description: .................... atkk-ud2
Eth Format: ..................... 802.2-Untagged
Priority: ....................... 5
Protocol: ....................... 0x8035 (RARP)
Number of References: ........... 0
Number of Active Associations: .. 0