User's Manual 108 Document #: LTRT-68822
Mediant 2000
 To configure IP network interfaces:
1. Open the IP Settings page (Configuration tab > VoIP menu > Network submenu > IP
Settings).
Figure 11-2: IP Settings Page (Single Network Interface)
Note: The IP Settings page appears only in the following circumstances:
• Upon initial configuration (i.e., IP interfaces have never been configured).
• The Multiple Interface Table button has not been clicked in any previous access to
this page and only a single IP address has been configured.
• The device has been restored to default settings.
If you have clicked the Multiple Interface Table button or have configured multiple
interfaces using any other non-Web management tool, the Multiple Interface Table
page appears instead of the IP Settings page.
2. To access the Multiple Interface table so that you can configure multiple network
interfaces, click the Multiple Interface Table button, located under the Multiple
Interface Settings group; a confirmation message box appears:
Figure 11-3: Confirmation Message for Accessing the Multiple Interface Table
3. Click OK; the Multiple Interface Table page appears:
Figure 11-4: Multiple Interface Table
4. In the 'Add Index' field, enter the desired index number for the new interface, and then
click Add Index; the index row is added to the table.
To Next Page
Loading...
Need help?
General
