AudioCodes Mediant 2000 User Manual

User's Manual 616 Document #: LTRT-68822
Mediant 2000
Parameter Description
Web: MLPP Normalized
Service Domain
EMS: Normalized Service
Domain
[MLPPNormalizedServic
eDomain]
Defines the MLPP normalized service domain string. If the device
receives an MLPP ISDN incoming call, it uses the parameter (if different
from ‘FFFFFF’) as a Service domain in the SIP Resource-Priority
header in outgoing INVITE messages. If the parameter is configured to
‘FFFFFF’, the Resource-Priority header is set to the MLPP Service
Domain obtained from the Precedence IE.
The valid value is 6 hexadecimal digits. The default is ‘000000’.
Note: This parameter is applicable only to the MLPP NI-2 ISDN variant
with CallPriorityMode set to 1.
[MLPPNetworkIdentifier]
Defines the MLPP network identifier (i.e., International prefix or
Telephone Country Code/TCC) for IP-to-ISDN calls, according to the
UCR 2008 and ITU Q.955 specifications.
The valid range is 1 to 999. The default is 1 (i.e., USA).
The MLPP network identifier is sent in the Facility IE of the ISDN Setup
message. For example:
 MLPPNetworkIdentifier set to default (i.e., USA, 1):
PlaceCall- MLPPNetworkID:0100 MlppServiceDomain:123abc,
MlppPrecLevel:5
Fac(1c): 91 a1 15 02 01 05 02 01 19 30 0d 0a 01 05 0a 01 01 04 05
01 00 12 3a bc
 MLPPNetworkIdentifier set to 490:
PlaceCall- MLPPNetworkID:9004 MlppServiceDomain:123abc,
MlppPrecLevel:5
Fac(1c): 91 a1 15 02 01 0a 02 01 19 30 0d 0a 01 05 0a 01 01 04 05
90 04 12 3a bc
Web: MLPP Default
Service Domain
EMS: Default Service
Domain
[MLPPDefaultServiceDo
main]
Defines the MLPP default service domain string. If the device receives a
non-MLPP ISDN incoming call (without a Precedence IE), it uses the
parameter (if different than “FFFFFF”) as a Service domain in the SIP
Resource-Priority header in outgoing (Tel-to-IP calls) INVITE
messages. This parameter is used in conjunction with the parameter
SIPDefaultCallPriority.
If MLPPDefaultServiceDomain is set to 'FFFFFF', the device interworks
the non-MLPP ISDN call to non-MLPP SIP call, and the outgoing
INVITE does not contain the Resource-Priority header.
The valid value is a 6 hexadecimal digits. The default is "000000".
Note: This parameter is applicable only to the MLPP NI-2 ISDN variant
with CallPriorityMode set to 1.
[RPRequired]
Determines whether the SIP resource-priority tag is added in the SIP
Require header of the INVITE message for Tel-to-IP calls.
 [0] Disable = Excludes the SIP resource-priority tag from the SIP
Require header.
 [1] Enable = (Default) Adds the SIP resource-priority tag in the SIP
Require header.
Note: This parameter is applicable only to MLPP priority call handling
(i.e., only when the CallPriorityMode parameter is set to 1).

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English