Avaya S8700 - Page 1008

Maintenance-Object Repair Procedures
555-233-143
8-286 Issue 1 May 2002
Connection Audit Test (#50)
Nondestructive (in a sane switch environment).
The Connection Audit test updates TDM time slots. It sends network-update
Control Channel Message Set (CCMS) messages that tell the ATM-TRK circuit
pack to listen to, talk to, or disconnect particular time slots.
The test passes if software successfully sends the downlink network-update
messages. It aborts otherwise.
!
CAUTION:
Though normally nondestructive, this test could unintentionally tear down an
active call if the connection-manager software’s tables are corrupt.
Table 8-122. Test #50 Connection Audit Test
Error
Code
Tes t
Result Description / Recommendation
None,
2100
ABORT System resources required for this test are not available.
Retry the command up to 5 times at 1-minute intervals.
1019 ABORT The test aborted because a test was already running on the port.
Retry the command up to 5 times at 1-minute intervals.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS The circuit pack has been updated with its translation.
0NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check the board translations.
2. If the ATM-TRK circuit pack is not administered, run add atm trunk
UUCSS.
3. If the ATM-TRK circuit pack is administered correctly, check the error log.
4. If ATM-TRK circuit pack is hyperactive, shut down, and reseat the circuit
pack to force re-initialization.
5. If the ATM-TRK circuit pack is correctly inserted, run busyout board.
6. Run reset board.
7. Run release busy board.
8. Run test board long to re-establish the linkage between the internal ID
and the port.
Continued on next page