refresh ip-route
Issue 1 May 2002
7-243555-233-143
refresh ip-route
Occasionally the tables used to route IP messages become corrupted and/or
contain stale routes, delaying packet delivery. This command removes every
dynamic (learned) route from the TN799 (C-LAN) circuit pack’s route tables and
replaces any of the stale (administered) routes that have become corrupted.
NOTE:
This command is call-preserving.
.
Output
The following example shows the output from the refresh ip-route command.
refresh ip-route form using the “all” qualifier
I
Table 7-38. refresh ip-route command parameters
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
refresh
ip-route
all
location
Refreshes every C-LAN
circuit pack in a switch
Refreshes the ip-route tables
in a specific C-LAN circuit
pack (CCcss)
init
inads
craft
station and
trunk MSP
permissions
all None
refresh ip-route all
REFRESH IP ROUTE
Board Maintenance Refresh Routes Routes Failure
Location Name Result Deleted Added Reason
05B11 CLAN-BD Fail 0 0 SNMP
01A11 CLAN-BD Success 0 0
Command successfully completed
Command:
To Next Page
Loading...
