Avaya S8700 - Reset Fiber-Link

reset fiber-link
Issue 1 May 2002
7-255555-233-143
reset fiber-link
reset fiber-link fiber# [a-pnc | b-pnc]
NOTE:
This command is not valid for S8700 IP Connect configurations.
!
CAUTION:
The reset fiber-link command is destructive on a high-reliability system
(unduplicated PNC), and may cause an entire port network to be removed
from service.
This command resets the Expansion Interface and/or Switch Node Interface
circuit packs that are endpoints of a specified fiber link, dropping the link in the
process.
A fiber link must be busied out before being reset. To busyout a fiber on
critical-reliability systems, the fiber must be on the standby PNC and the standby
PNC must first be busied out. See
busyout fiber-link for associated interactions.
The
list fiber-link command displays a list of fiber links and their locations.
Parameters
Examples
High-reliability system (unduplicated PNC): reset fiber-link 1
Critical-reliability system (duplicated PNC): reset fiber-link 1
fiber# The administered number of the fiber link (1-44). On a critical-reliability system
(duplicated PNC), this number designates a fiber link pair; the following qualifier
specifies which fiber in the pair is to be reset.
a-pnc, b-pnc For a critical-reliability system (duplicated PNC), this distinguishes between the two
fibers in a duplicated pair. On a high-reliability system (unduplicated PNC) this is
always a-pnc and need not be specified.