Avaya S8700 - Status Ip-Board

Maintenance Commands
555-233-143
7-352 Issue 1 May 2002
status ip-board
status ip-board CCcss
The status ip-board command runs on R10 or later systems. The command has
the same syntax and output as the status c-lan-ip command except the list of
allowed boards is larger. The command can be run on either a TN799 or a
TN2302.
NOTE:
This SAT command cannot be run on the MAPD board.
The command status ip-board
CCcss returns the data in the first two columns of
the following table. The form also shows the time of the last port reset, the last
hour start time and end time for the error counter statistics.
Table 7-51. status c-lan-ip CCcss
Field Name
on switch
output Output type MIB data Description
Incoming
datagram
header errors
Counter Long ipInHdrErrors The number of input datagrams
discarded due to errors in their IP
headers, including bad checksums,
version number mismatch, other
format errors, time-to-live exceeded,
errors discovered in processing their
IP options, and so on.
Outgoing
datagrams
with no route
available
Counter Long ipOutNoRoutes The number of IP datagrams
discarded because no route could be
found to transmit them to their
destination. Note that this counter
includes any packets counted in
ipForwDatagrams which meet this
`no-route’ criterion. Note that this
includes any datagrams which a host
cannot route because all of its default
gateways are down.
Incoming
datagrams
received
Counter Long ipInReceives The total number of input datagrams
received from interfaces, including
those received in error.
Continued on next page