Maintenance Commands
555-233-143
7-12 Issue 1 May 2002
Contention Between Simultaneous
Commands
The following limits apply to simultaneous maintenance and administration
activities:
■ Up to 15 users can be logged into the system at the same time.
■ Up to five maintenance commands can run concurrently.
■ Up to 10 administration commands can run concurrently.
■ In general, a maintenance object or other system entity can be acted upon
by only one command at a time. This restriction applies to such action
commands as:
— busyout
— change
— clear
— recycle
— release
— set
— test
■ When an action command is acting on a circuit pack, that circuit pack and
every maintenance object located on it are unavailable for other
commands.
■ Display-only commands such as the following generally do not conflict with
any other commands:
— display
— status
— get
— monitor
■ Most commands require the use of shared system resources in order to
execute. When required resources are already in use, the command will
abort. Only one such command can run at one time.
To Next Page
Loading...
