Maintenance Commands
555-233-143
7-346 Issue 1 May 2002
status hardware-group
status hardware-group [print]
Summary information about the active or last hardware group tests will be
displayed. This display includes the number and percentage of maintenance
objects tested, the percentage of tests passed/failed/aborted, the time elapsed
since initiating the hardware group test, the specific hardware group test
command (see test hardware-group command) initiated, and the state
(active/canceled/complete) of the hardware-group test.
Output
The following display shows a typical result when status hardware-group is
entered.
status hardware-group page 1 of 1
HARDWARE GROUP STATUS
Hardware Group Command State: active
Number of MOs Tested: 11070
Total Number of MOs to be Tested: 12300
Percent Complete: 90%
Elapsed Test Time (hr:min:sec): 4:15:30
Repetition Number: 1
Percentage of Tests Passed: 82%
Percentage of Tests Failed: 11%
Percentage of Tests Aborted: 7%
ENTERED HARDWARE GROUP Command
Command: test hardware-group system
Test sequence: short
Test repetition: repeat 3
Output Options: failures
Hardware Options: all-ports
To Next Page
Loading...
