Maintenance Commands
555-233-143
7-262 Issue 1 May 2002
reset maintenance
reset maintenance UUC
NOTE:
This command is not valid for S8700 IP Connect configurations.
This command performs a reset on a specified maintenance circuit pack.
Specifying cabinets 1 through 44 resets the EPN’s Maintenance circuit pack in the
‘a’ carrier of the specified cabinet, dropping any local login to that circuit pack.
Output
The following screen shows results from reset maintenance on an S8700
Multi-Connect system.
reset maintenance
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01A MAINT 306 PASS
Command successfully completed
To Next Page
Loading...
