display system-parameters duplication
Issue 1 May 2002
7-141555-233-143
display system-parameters duplication
This command displays the status (enabled or disabled) of IPSI (processing
element) and PNC (port network connectivity) duplication. The following must be
duplicated:
■ Each switch node record and every switch node with its duplicate (cabinet
administration is a prerequisite)
■ Every fiber link containing either an EI circuit pack as an endpoint, or a
DS1-C (fiber link administration is a prerequisite; circuit pack administration
then follows duplication administration)
Every unduplicated SNI (switch node interface) to an SNI fiber link is automatically
duplicated.
NOTE:
The PNC Duplication field must be enabled on the customer options
form before you can do any duplication administration. If not, you must
obtain a license file to enable this option.
PNC duplication cannot be enabled until every pnc-a and -b board is
released from the “busyout” state.
Table 7-18. display system-parameters duplication command parameters
Action/Object Qualifier Qualifier Description Permission Default
Feature
Interaction
display
system-
parameters
duplication IPSI or PNC duplication
Examples:
display
system-parameters
duplication
init
inads
craft
none none
To Next Page
Loading...
