Maintenance Commands
555-233-143
7-142 Issue 1 May 2002
Output
The following example shows the output from the display system-parameters
duplication
command.
Field Descriptions
Enable Operation of
PNC Duplication?
Status of PNC duplication: y is enabled; n (default) id disabled.
This field appears only if
PNC Duplication has been enabled
on the System Parameters Customer Options form.
Enable Operation of
IPSI Duplication?
Status of IPSI duplication: y is enabled; n (default) is disabled
display system-parameters duplication
DUPLICATION RELATED SYSTEM PARAMETERS
Enable Operation of PNC Duplication? y
Enable Operation of IPSI Duplication? y
To Next Page
Loading...
