set synchronization
Issue 1 May 2002
7-285555-233-143
set synchronization
This command sets a specific DS1 trunk, Tone-Clock circuit, or ATM switch as the
reference source for system synchronization signals. It is permitted only after
synchronization has been disabled with
disable synch. Any administered DS1
trunk or
active Tone-Clock may be entered with the set command. The DS1 or
Tone-Clock will remain the synchronization reference until either the set command
specifies another circuit pack, or
enable synchronization is entered.
After an
enable synchronization, the administered primary or secondary
synchronization source will become the synchronization reference. If no primary
or secondary source is administered, the active Tone-Clock is used as the
synchronization reference.
This command is not supported when ATM-PNC is enabled.
Output
Table 7-44. set synchronization command parameters
Action/ Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
set synchronization print init
inads
craft
none none
set synchronization 8a01
Command successfully completed
Command:
To Next Page
Loading...
