Maintenance Commands
555-233-143
7-290 Issue 1 May 2002
status access-endpoint
status access-endpoint extension [print]
This command displays the operational of a non-signaling port on a DS1 interface
or on an analog tie trunk circuit pack.
Output
The following display shows a typical result when status access-endpoint 2300
is entered.
Field Descriptions
Extension
The extension number of the specified port.
Port
The physical location (cabinet-carrier-slot-circuit) of the port.
Communication
Type
The type of communication supported by the channel: 56k-data, 64k-data, or
voice-band-data.
Service State
The operational status of the access-endpoint channel: in-service/idle,
out-of-service, maintenance-busy or disconnected.
Connected
Ports
The location of any facility/endpoint to which this access-endpoint is
connected.
status access-endpoint 2300
ACCESS ENDPOINT STATUS
Extension: 2300
Port: 02B0905
Communication Type: 56k-data
Service State: disconnected
Connected Ports:
To Next Page
Loading...
