Maintenance Commands
555-233-143
7-396 Issue 1 May 2002
status sys-link
status sys-link UUCSSpp [ channel] [print]
The status sys-link command displays status data for a specified system link. The
report includes the type and operational state of the link, the associated processor
channel, if any, active alarms and path status, and a list of all hardware
components making up the link’s path. If, in addition to the current path, a faulted
path exists, the components making up the faulted path are displayed on page 2
of the report.
For port networks with IPSI, this command also provides status for a BFD link.
The information shown is similar to other link types.
Parameters
Examples
status sys-link 1e0201
Output (for S8700 IP Connect)
The following display shows a typical result when status sys-link 8a02 is
entered.
UUCSSpp The link is specified by giving the location of the port associated with the link.
status sys-link 8a02 Page 1 of 2
Location: 08A0201 Type/Chan: EAL Alarms: none
Current Path: present State: up Time Up: 03/20/2002 15:49
Faulted Path: none Last Fault:
Current Hardware Path
Maintenance Maintenance
Location Name Alarms Location Name Alarms
08A PKT-INT none
PN 08 PKT-BUS none
08A IP-SVR none
To Next Page
Loading...
