Avaya S8700 - Test Packet-Interface

test packet-interface
Issue 1 May 2002
7-449555-233-143
test packet-interface
test packet-interface [Uc] [short | long] [repeat# |clear] [schedule]
This command performs hardware diagnostic tests on any or all of the Packet
Interface circuit packs in a specified carrier. Tests performed include local
memory checksum tests, loop-around tests, and checks of failure counters.
The Maintenance Loop-Around test (#886) is included in the test sequences of
active packet-interface circuit packs only. The Active-Standby Peer Link test
(#888) is included in the test sequences of the
standby packet-interface circuit
packs only.
If the packet-interface circuit pack is in the “out-of-service” or “uninstalled” states,
no demand tests as well as scheduled, periodic and error tests will run. See also
reset packet-interface and status packet-interface.
Parameters
U cabinet (1-44) Specify the cabinet number with the IPSI board you
want to test.
c carrier Supply the carrier you want to test.