Avaya S8700 - Set Boot-Image

Maintenance Commands
555-233-143
7-270 Issue 1 May 2002
set boot-image
Use this command to direct the system to use 1 of 2 possible firmware image files
on the TN2501AP circuit pack.
NOTE:
You must reseat the circuit pack before the firmware file specified in this
command becomes the active boot image.
Table 7-42. set boot-image command parameters
Action/Object Qualifier Qualifier Description Permissions
Default
s
Feature
Interactions
set boot-
image
board
location
1
2
The physical location of the
circuit pack (UUCSS)
Directs the system to use the
Image 1 firmware file
Directs the system to use the
Image 2 firmware file
Example
set boot-image board 1B08
init
inads
craft
customer