Maintenance Commands
555-233-143
7-420 Issue 1 May 2002
test board
test board UUCSS [short | long] [repeat# | clear] [schedule]
The test board command will validate that the board exists at the specified
location. Based on the logical type (for example, Analog, Digital, Hybrid) of board
a series of tests will be executed. Each individual test will exercise diagnostics on
the board and then return results of the test along with any possible error codes.
Destructive long tests on a Switch Node Interface (SNI) board are not allowed
unless the board has been busied out.
For more information, see the following sections: ‘‘Common Input Parameters’’
on page 7-6 and ‘‘Common Output Fields’’ on page 7-9.
The following display shows a typical result when
test board 1D07 is entered and
slot 1D07 hods a Digital Line circuit pack with 7 ports administered.
test board 1d07 short
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
01D07 DIG-BD 52 PASS
01D0701 DIG-LINE 5401 16 PASS
01D0701 DIG-LINE 5401 17 PASS
01D0702 PDMODULE 5460 17 PASS
01D0703 PDMODULE 5461 17 ABORT 5
01D0704 PDMODULE 5444 17 ABORT 5
01D0705 DIG-LINE 16 ABORT 1392
01D0705 DIG-LINE 17 ABORT 1392
01D0706 DIG-LINE Attd2 16 PASS
01D0706 DIG-LINE Attd2 17 PASS
01D0707 DIG-LINE Attd1 16 PASS
01D0707 DIG-LINE Attd1 17 PASS
Command successfully completed
To Next Page
Loading...
