test led
Issue 1 May 2002
7-445555-233-143
test led
test led [all | cabinet UU | port-network PN# | switch-node SN# | a-pnc |
b-pnc] [repeat#]
This command verifies that a specified cabinet, port network, PNC or switch node
is recognized by the system. It is also useful for identifying a port network,
cabinet, or PNC (A or B).
When
test led is entered, the red, green and yellow circuit pack LEDs are turned
on until all administered carriers in the specified group have been lit for 2 seconds.
They are then turned off in the same order in which they came on. The cycle can
be repeated a number of times with the
repeat option. Once every repeat cycle is
completed, every affected LED is restored to reflect its current status.
To Next Page
Loading...
