Maintenance Commands
555-233-143
7-422 Issue 1 May 2002
test customer-alarm
test customer-alarm UUC [short | long] [repeat# | clear] [schedule]
NOTE:
This command is not valid for S8700 IP Connect configurations.
The test customer-alarm command performs hardware diagnostic tests on the
leads of the EPN’s Maintenance circuit pack in a specified cabinet. These leads
are connected to customer equipment and provide a means of alerting the system
administrator and INADS when that equipment fails. The alarm is activated when
a relay on the connected equipment is closed for 1 minute.
The cabinet default is 1.
To Next Page
Loading...
