Maintenance Commands
555-233-143
7-230 Issue 1 May 2002
monitor traffic
monitor traffic trunk-groups [starting-group#]
monitor traffic hunt-groups
The monitor traffic command shows the current load on specified trunk and hunt
groups and the length of time that the oldest call in the group has been waiting.
Parameters
Output
The following display shows a typical result when mon tr hu is entered.
trunk-groups
[starting-group#]
The trunk group report displays the number of calls in the queue waiting to be
serviced for each trunk group. The total number of members in the group and the
number of members active on calls are displayed for comparative analysis. Only
administered trunk groups up to a maximum of 60 are displayed.
You can specify the starting trunk group. For example, if you enter 5, trunk
groups from group 5 up are displayed.
hunt-groups The hunt-group report is similar to the trunk-group report. In addition to the
information contained in the trunk-group report, this report displays how long the
oldest call in each group’s queue has been waiting. The display is updated
(refreshed) every minute. Fields are blank for unadministered hunt groups.
monitor traffic hunt-groups
HUNT GROUP STATUS 22:49 G3-MT DEC 31 2002
# S A Q W LCIQ # S A Q W LCIQ
1 15 10 10 0 20 17
2 18
3 19
4 20
5 21
6 22
7 23
8 24 10 5 0 0 10
9 25
10 26
11 27
12 28
13 29
14 30
15 31
16 32
(#: Group; S: Grp Size; A: Active Members; Q: Q Length; W: Calls
Waiting)
To Next Page
Loading...
