Maintenance Commands
555-233-143
7-204 Issue 1 May 2002
list pms-down
list pms-down [start-time] [stop-time] [print]
This command lists every event that has meaning to the Property Management
System (PMS) that have occurred while the link between the switch and the PMS
was down. For example, any room status codes entered by hotel housekeeping
staff during a time of PMS outage would be shown in this report.
Parameters
Output
The following example shows a typical result when list pms-down is entered.
Field Descriptions
start-time
The starting time in 24-hour notation from which events are to be listed.
stop-time
The time in 24-hour notation up to which events are to be listed.
Extension
The extension associated with the reported event.
Event
The PMS event that was reported to the switch, but which could not be sent to the
PMS.
Reason
The reason that the event could not be reported by the switch to the PMS.
Time
The time at which the event was reported.
list pms-down
PROPERTY MANAGEMENT SYSTEM ACTIVITY
Extension Event Reason Time
402 from room, code 1 PMS link out of service 7:00am
405 from stn, code 1 PMS link out of service 9:00am
411 check in, complete PMS link out of service 9:30am
411 PBX enabled MWL PMS link out of service 12:00am
450 from room, code 1 PMS reject 12:05am
To Next Page
Loading...
