LED Interpretation
555-233-143
6-16 Issue 1 May 2002
Server LEDs
The server has an LED called Active/Standby that indicates whether the server is
the active server or the standby server. The Active/Standby LED in the “on” state
implies active and in the “flashing” state implies standby. It flashes at the rate of
400 ms “on” and 600 ms “off” when in standby mode.
Figure Notes:
1. Power
2. Configuration fault
3. Disk activity
4. Network activity (not used)
5. Service—configuration health (not used)
6. Active or standby mode indicator
7. U2 (not used)
8. 4 NIC ports (the numbers indicate their assigned Ethernet ports)
9. LEDs for the NIC ports
10. LEDs for fiber optic duplication connectivity
11. Status LED (not used)
Figure 6-4. Media Server LEDs—Front and Back
1
SERVICE
U2
STANDBY
ACTIVE
2
1
55 44 33
22
DAI - 1
DUP
M
EMOR
Y
LINE
RECEIVE
TRANS
LINK
STAT
AVAYA
1 2
3 44 5
6
7
9
10
11
8
scdlled KLC 030502
To Next Page
Loading...
