Maintenance Commands
555-233-143
7-364 Issue 1 May 2002
status logins
status logins [print]
This command will display information about all of the users that are currently
logged into the system. This information will contain their login names, location of
physical access, and their currently executing command.
The screen does not automatically update, and is a reflection of the system at the
time the request was made. Users may have logged off, or on, or the command
may have finished executing while the information is being displayed. These
updates will not be reflected until the next execution of the command.
The command will take a snapshot of the commands that the users on the system
are currently executing. Because of timing, the command could be terminated by
the time this command finishes displaying the list (that is, the active command
may not be accurate).
The following is an example of the results of the
status logins command:
status logins
USER LOGIN INFORMATION
Login Type Location Aux Active Command ID
*init SYS-PORT TELNET 135.9.38.18 stat logins 2
Command successfully completed
To Next Page
Loading...
