Avaya S8700 - Display Node-Names

display node-names
Issue 1 May 2002
7-139555-233-143
display node-names
This command displays a list of the administered node names.
Output
The following example shows the output from the display node-names
command.
Page 1
Field Descriptions (Page 1)
Table 7-17. display node-names command parameters
Action/ Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
display
node-names
print
schedule
Example:
display node-names
init
inads
craft
none none
Audix Name
Identifies the name of the adjunct or switch node. Enter 1-7 characters for
audix or msa; 1-20 characters for others. Default is blank.
IP Address
IP address for the adjunct or switch. Enter 0 – 255 or leave blank
(default).
MSA Names
MSA node name (up to 7 characters)
IP Address
IP address for the adjunct or switch. Enter 0 – 255 or leave blank
(default).
page 1 of 6
NODE NAMES
Audix Name IP address MSA Names IP Address
1. _______ ___.___.___.___ 1. _______ ___.___.___.___
2. _______ ___.___.___.___ 2. _______ ___.___.___.___
3. _______ ___.___.___.___ 3. _______ ___.___.___.___
4. _______ ___.___.___.___ 4. _______ ___.___.___.___
5. _______ ___.___.___.___ 5. _______ ___.___.___.___
6. _______ ___.___.___.___ 6. _______ ___.___.___.___
7. _______ ___.___.___.___ 7. _______ ___.___.___.___
8. _______ ___.___.___.___