Avaya S8700 - M;T-ANL (Maintenance;Test Analog Port)

M/T-ANL (Maintenance/Test Analog Port)
Issue 1 May 2002
8-1147555-233-143
M/T-ANL (Maintenance/Test Analog
Port)
The Maintenance/Test analog port is port number 1 on the TN771D Maintenance/
Test circuit pack. This port is used by the Automatic Transmission Measurement
System (ATMS) as an Originating Test Line (OTL) or Terminating Test Line (TTL)
for test calls over analog trunks. For more details, see “Automatic Trunk
Transmission System” in Chapter 5, ‘‘Additional Maintenance Procedures’’.
Figure 8-66 shows a typical ATMS configuration.
M/T-ANL maintenance ensures that the analog trunk’s testing function is
operating correctly. Although an M/T-ANL alarm can reduce service, it will not
block service. To accurately measure the performance and health of analog
trunks, replace an alarmed TN771D when a new circuit pack is available.
Figure 8-66. ATMS Tie Trunk Test Call
MO’s Name (in
Alarm Log)
Alarm
Level
Initial SAT Command to
Run
1
1. UU is the universal cabinet number (1–64 for ATM PNC, 1–44 for CSS PNC). C is the carrier designation (A,
B, C, D, or E). SS is the number of the slot where the circuit pack resides (01–21). pp is the 2-digit port number
(01, 02,...).
Full Name of MO
M/T-ANL Minor test port UUCSSpp l Maintenance/Test analog port
M/T-ANL Warning release port UUCSSpp Maintenance/Test analog port
Tie
Trunk
Facilities
Originating
Test Line
(OTL)
TN771
TDM Bus
Terminating
Test Line
(TTL)
TN771
TDM Bus
PBX originating
the test call
PBX terminating
the test call
Tie Trunk
Circuit Pack
Tie Trunk
Circuit Pack