ERR-LOG (Error Log)
Issue 1 May 2002
8-743555-233-143
ERR-LOG (Error Log)
The ERR-LOG MO is responsible for the sanity of the Alarm Log, the Hardware
Error Log, and the Software Error Log. If an inconsistency is detected in any one
of these logs, every log will be re-initialized and a hardware error will be logged
against ERR-LOG indicating the time of inconsistency. There are no tests and no
alarms for the Error Log MO. This MO exists solely for the purpose of allowing
errors to be logged against it.
Hardware Error Log Entries
Notes:
a. Indicates that an inconsistency was detected in either the Alarm Log, the
Hardware Error Log, or the Software Error Log. The system attempts to
recover the logs but, depending on the extent of the corruption, some or all
entries in the logs may be lost. Any alarms that were active at the time of
this error have been cleared. There is no associated test for this error.
The Aux Data value indicates when the inconsistency was found:
MO’s Name (in
Alarm Log) Alarm Level Initial Command to Run Full Name of MO
ERR-LOG none none Error Log
Error
Type Aux Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
510 (a) See below none none none none
0 During a periodic audit of the Error Log
1 After an extended reboot
2 After a reboot
4 After a Level-3 System Reset (COLD_1)
8 After a Level-2 System Reset (COLD_2)
16 After a Level-1 System Reset (Warm Start)
100 After an internal software audit
2500 After a single-process (MDM) restart
To Next Page
Loading...
