test analog-testcall
Issue 1 May 2002
7-419555-233-143
test analog-testcall
The test analog-testcall command causes the Automatic Transmission
Measurement System (ATMS) to originate a test calls over analog trunks. ATMS
collects performance measurements on the test call and compares them to
administered thresholds. Detail and summary reports of these measurements are
generated with the
list testcalls command.
You can specify testing of an entire trunk group or an individual trunk using either
group/member addresses or port and circuit pack location. The type of test call,
the number of the testing line on the far-end switch and various other parameters
must be administered on the Trunk Group form before the command can execute.
ATMS, the operation of this command, and the measurement reports are
described in Automatic Transmission Measurement System (ATMS) in Chapter 5,
‘‘Additional Maintenance Procedures’’.
test analog-testcall trunk-group# / member# | port UUCSSpp | board UUCSS
[full | supervision | no-selftest | no-return-loss | no-st-or-rl]
[repeat#] [schedule]
To Next Page
Loading...
