Avaya S8700 - AN-LN-PT (Analog Line Port)

AN-LN-PT (Analog Line Port)
Issue 1 May 2002
8-101555-233-143
AN-LN-PT (Analog Line Port)
The TN793B/TN2793B Analog Line (w/ Caller ID) and the TN797 Analog Trunk
and Line circuit packs both support this MO.
The TN793B/TN2793B Analog Line circuit pack (w/ Caller ID) provides 24 ports
for voice terminals and supports both on-premises and off-premises analog voice
terminals.
The TN797 Analog Trunk and Line circuit pack provides 8 ports, each of which
may be administered in any of several ways, as described in MO TR-LN-BD.
NOTE:
The TN793B/TN2793B analog line circuit pack supports analog data
modules. When assigned, analog data modules provide access to the
NetPkt (TN794 circuit pack) data ports. To activate an analog data module
you must assign the port location on the data form and connect a modem to
the port. The analog data module can be used for connection to a CDR
output, or other adjuncts as needed. These ports are tested like any other
analog port on the circuit pack.
Ringing caused by maintenance testing
Test #48 may cause some terminal equipment to ring briefly during daily
maintenance. If this ringing disturbs the customer or the terminal equipment,
disable it in the Tests field of the change station extension form. Be aware that
this action also disables Tests #6, 7, 161, and 35 on some software releases.
MO’s Name (in
Alarm Log) Alarm Level Initial Command to Run
1
1. UU is the universal cabinet number (1–64 for ATM PNC, 1–44 for CSS PNC). C is the carrier
designation (A, B, C, D, or E). SS is the number of the slot where the circuit pack resides (01–21).
pp is the 2-digit port number (01, 02, 03 ...).
Full Name of MO
AN-LN-PT MINOR test port UUCSSpp l Analog Line port
AN-LN-PT WARNING test port UUCSSpp sh Analog Line port