Avaya S8700 - Release Commands

release commands
Issue 1 May 2002
7-247555-233-143
release commands
release board UUCSS
release
maintenance-name [address]
Release commands release specified maintenance objects from the maintenance
busyout state and puts them back into service, assuming the health of the
component(s) permits. Hardware tests specific to the maintenance object are
performed to verify that it is functioning.
For each maintenance object, the release command is entered in the same
fashion as the associated busyout command, except that the word
release is
entered instead of
busyout. See the description of the related busyout command
for details of command syntax.
If a release command is entered for an object that is not busied out, the command
will abort. Some release commands trigger recovery actions by the system, such
as the refresh of a standby PNC. See the description of the related busyout
command for details of command execution and interactions.
Parameters
Input parameters consist of specifying the location, if required, of the given
maintenance object. Use the same format as that used for the related busyout
command.
Examples
release board 01c11
release data-module 310
release Tone-Clock 2a
release ds1-fac 02e01a
release fiber-link 13
release port UUCSSpp
release station extension