Maintenance Commands
555-233-143
7-268 Issue 1 May 2002
resume hardware-group
resume hardware-group
In the course of execution of a test hardware-group command, it may be
desirable to halt the test temporarily or permanently. This is accomplished by
either the
cancel hardware-group command for a background test, or by
pressing
CANCEL for a foreground test. Resume hardware-group enables you to
restart the hardware group test at the point where it was canceled. This capability
is not available if another hardware group test has been started. The status of a
hardware group test can be obtained with
status hardware-group.
When
test hardware-group all-ports is canceled, the internally generated port
translations for previously untranslated ports are removed. If
resume
hardware-group
is then entered, only customer-administered ports will then be
tested.
resume does not reinstate the port translations that were removed by
cancellation of the test.
Output
When a test that was executing in the background is resumed, a success
message is displayed. When a test that was executing in the foreground is
resumed, test results are displayed.
To Next Page
Loading...
