Maintenance Commands
555-233-143
7-56 Issue 1 May 2002
change circuit packs
change circuit-packs UU
This command allows the user to administratively add, change or remove circuit
packs that are to be inserted into port, expansion control, and switch node
carriers. It is used to configure the system when the circuit packs have not yet
been physically inserted. This command does
not support displaying or modifying
the boards in the PPN control carrier.
Parameters
Output
The following display shows a typical result when change circuit-packs is
entered for Cabinet 1. The following five screens were taken from an S8700
Multi-Connect configuration.
UU The number of the cabinet containing the circuit packs to be modified. Default is 1.
For S8700 IP Connect configurations, the number applies to port slots 1-10 only.
change circuit-packs Page 1 of 5
CIRCUIT PACKS
Cabinet: 1 Carrier: A
Cabinet Layout: five-carrier Carrier Type: expansion-control
Slot Code Sf Mode Name Slot Code Sf Mode Name
11: TN799 C CONTROL-LAN
01: TN570 D EXPANSION INTF 12:
02: 13:
03: TN464 G DS1 INTERFACE 14: TN754 C DIGITAL LINE
04: TN2198 BRI LINE 15: TN793 B ANALOG LINE
05: TN748 D TONE DETECTOR 16:
06: TN464 F DS1 INTERFACE 17:
07: TN464 G DS1 INTERFACE 18: TN767 E DS1 INTERFACE
08: TN464 F DS1 INTERFACE 19:
09: TN464 F DS1 INTERFACE
10: TN464 F DS1 INTERFACE
’#’ indicates circuit pack conflict.
To Next Page
Loading...
