Avaya S8700 - Display Initcauses

display initcauses
Issue 1 May 2002
7-135555-233-143
display initcauses
display initcauses [print | schedule]
The display initcauses command displays a history of recovery steps taken by
the system.
This command displays information for restarts of the active
processor only
. Whenever the processor resets and the system is restarted,
whether initiated by a technician command or by system software, information
about the recovery is stored. If the reset is escalated, only the reset that
successfully completes is recorded. Information about the reset may also be
found in the error log. When a reset 4 (reload) occurs, the error log is saved on
the disk.
Records of the last 16 restarts are retained in the initcauses log in chronological
order. A power failure results in loss of every record in the initcauses log.
Output (for S8700 Multi-Connect)
display initcauses
INITIALIZATION CAUSES
Cause Action Escalated Time
Internal Request 1 no 03/15 06:24
Initialized 4 no 03/15 11:41
Internal Request 1 no 03/15 11:42
Internal Request 1 no 03/15 11:42
Internal Request 1 no 03/15 14:41
Craft Request 2 no 03/18 11:11
Initialized 4 no 03/18 16:25
Internal Request 2 no 03/19 14:17
Internal Request 1 no 03/19 14:17
Initialized 4 no 03/19 17:56
Initialized 4 no 03/20 10:25
Initialized 4 no 03/20 11:24
Initialized 4 no 03/20 11:31
Craft Request 2 no 03/20 12:07
Craft Request 2 no 03/20 12:16
Craft Request 1 no 03/20 15:30
Command successfully completed