Maintenance Commands
555-233-143
7-266 Issue 1 May 2002
reset system
reset system [level#]
!
CAUTION:
All system resets are service affecting, with higher levels being increasingly
destructive. Some resets may take up to one half hour to complete. Certain
conditions may result in a higher reset level than the one requested. Unless
you are experienced with resetting a system, follow normal escalation
procedures.
This command causes the Avaya Call Processing (ACP) application to be
reloaded.
All system resets (except reset system interchange) are disruptive and
terminate the G3-MT login.
System software will generally not escalate a demand system reset to a higher
level. There are certain conditions that result in a higher level reset than that
requested. These include the following:
■ A PNC interchange is already in progress.
■ A change in translation administration is in progress.
Parameters
Examples
reset system 1
Output
Once this command is entered, it may not be canceled. The screen will display
the results of various initialization tests. If the reset command is successful the
user will be logged off. Several conditions may prevent a requested reset.
Level Reset levels are numbered as shown in Table 7-41. The execution times listed are
approximations.
Table 7-41. Approximate Recovery Time for System Resets (min:sec)
Level Recovery 2,400 lines 5,000 lines 15,000 lines
Disk Disk Disk
1 Warm Restart :10 :10 :10
2 Cold-2 1:00 2:00 4:00
4 Reload 4:00 6:30 11:00
To Next Page
Loading...
