Avaya S8700 - ADM-CONN (Administered Connection)

Maintenance-Object Repair Procedures
555-233-143
8-12 Issue 1 May 2002
ADM-CONN (Administered
Connection)
An administered connection provides an end-to-end connection between two
access endpoints or data modules residing in either the same switch or different
switches. When administered, the connection is automatically established and
scheduled to be permanently active.
An error is logged whenever an administered connection fails or cannot be
established. Failures to establish a connection generate an error whether they
occur on an initial try, a retry, a fast retry, a redial or an auto-restoration. A failed
connection generates an error whether or not the connection is subsequently
reestablished by fast retry, redial, or auto restoration.
An alarm is logged when an administered connection cannot be established either
initially or after a connection failure. Both the alarm level (none to major) and a
failure threshold can be administered for each administered connection. An alarm
is raised when either of the following occurs:
■ The number of consecutive failed attempts to establish a connection
reaches the administered threshold.
■ Software determines that failure to establish a connection is due to a
mistake in administration. See Table 8-5.
Error Log Entries and Test to Clear Values
MO’s Name
(in Alarm Log) Alarm Level Initial Command to Run Full Name of MO
ADM-CONN MAJOR, MINOR,
or WARNING
status administered-connection N
1
1. Where N is an administered connection number indicated in the PORT field of the Alarm or Error Log.
Administered
Connection
Table 8-5. Administered Connection Error Log Entries
Error Type
Aux
Data
Associated
Te s t
Alarm
Level
On/Off
Board
Test to Clear
Val ue
0, or 29 Any None Any OFF None
1, or 28 (a, b) Any None Any OFF None
2 (c) Any None Any OFF None
6, 21, 31, or 127(d) Any None Any OFF None
16 (a) Any None Any OFF None
Continued on next page