Maintenance-Object Repair Procedures
555-233-143
8-328 Issue 1 May 2002
Table 8-141. Test #595 LANBIC Receive Parity Error
Counter Test
Error
Code
Tes t
Result Description / Recommendation
2000 ABORT Response to the test was not received from the circuit pack within the allowable
time period.
1. If the test aborts repeatedly up to five times, reset the circuit pack via the
busyout board UUCSS and reset board UUCSS commands.
2. If the test aborts again, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
1–10 FAIL The circuit pack is still detecting errors of this type. The error code indicates
the value of the on-board error counter.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, verify the validity of the packet bus. Run the
Packet Bus Maintenance test with the test pkt P long command. If any
packet-bus tests fail, see ‘‘PKT-BUS (Packet Bus)’’ on page 8-1230 for
recommended repair procedures.
3. If the Packet Bus test passes, check the validity of the circuit pack.
Execute a test that involves data transmission onto the packet bus. For
example, the BRI may use the connectivity tests of the port-level MO
(BRI-PORT) by executing the test port UUCSSpp command. Refer to the
repair procedures for the executed test if it fails. Otherwise, proceed to the
next step.
4. Other circuit packs on the packet bus can cause of the parity error. Use
the display errors command to check the Error Log for other circuit packs
that are alarmed. If any alarms are present for the other circuit packs,
retire those alarms also. Then, rerun the LANBIC Receive Parity Error
Counter test (#595) on this circuit pack.
PASS No errors detected by circuit pack.
Continued on next page
To Next Page
Loading...
