Avaya S8700 - Page 1062

Maintenance-Object Repair Procedures
555-233-143
8-340 Issue 1 May 2002
Figure 8-12. Path of the BRI Port Local LAN Loop Around
Table 8-144. Test #618 BRI Port Local LAN Loop Around
Error
Code
Tes t
Result Description / Recommendation
1015 ABORT The port is not in the out-of-service state.
1. Display the BRI Port Status form via the status bri-port PCSSpp
command to determine what stations or adjuncts are on this port.
2. Use the extension shown on this form in the status station command to
determine whether the station or adjunct is active.
3. If so, wait until it is idle, and then busyout the port (using the busyout port
PCSSpp command) to place it in the out-of-service state and repeat this
test.
!
WARNING:
Since the “busyout” command is destructive, execution of this command
prior to the port being idle causes every call associated with BRI
endpoints and every transaction associated with ASAI or Avaya adjuncts
on the port to be torn down. Note that 3
rd
-party calls established by an
ASAI or Avaya adjunct remain connected even though the port is taken
out-of-service.
Continued on next page
BRI LINE
CIRCUIT
PACK
PACKET
INTERFACE
PACKET BUS
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . .
.
.
.
.
.
. . . .