CO-TRK (Analog CO Trunk)
Issue 1 May 2002
8-473555-233-143
1115 ABORT The near-end test line on the TN771 circuit pack could not be allocated.
1. Verify that the TN771 circuit pack is in service and that port 1 is
administered and in service with the status port command.
2. Retry the command at 1-minute intervals up to 5 times.
1900 ABORT The test completion message was not received from the TN771 circuit pack.
1. Test the TN771 circuit packs.
1901 ABORT This error occurs when the TN771 circuit pack uplinks a message that is not
the proper response for this test. The anticipated uplink messages are seize,
ring or answer.
1. Verify that the trunk is administered properly.
1905 ABORT Intercept tone detected from far end.
1. Get the test line data from and verify it with the far end.
2. Dial the test number manually to see if the TTL is reached.
If not, then either the number is wrong or the far end is administered
incorrectly.
1906 ABORT Reorder tone detected from far end.
1. See actions for error code 1905.
1907 ABORT Other unexpected tone detected from far end.
1. See actions for error code 1905.
1913 ABORT Audible Ring detected from far end.
1. See actions for error code 1905.
1914 ABORT Unidentified interrupted tone detected from far end.
1. See actions for error code 1905
1915 ABORT Busy tone detected from far end.
1. Since the test line at the far end was busy, try the test again.
2. If the test continues to abort, the problem is with the far-end system.
1918 ABORT Test progress tone not removed from far end (type 105 test line only).
1. The problem is with the far-end system; a technician at the far end should
test the test line (TN771 or ADFTC).
1919 ABORT Unexpected far-end release
1. The problem is with the far-end system; a technician at the far end should
test the test line (TN771 or ADFTC).
Table 8-190. Test #844-848 Transmission Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
