CONFIG (System Configuration)
Issue 1 May 2002
8-477555-233-143
The Error Type field specifies the carrier and slot location of the circuit pack
that caused the error as indicated in Table 8-192. If the Error Type field is
greater than 1000, subtract 1000 from the Error Type field before consulting
the table.
Before proceeding, if multiple CONFIG errors are simultaneously logged with an
Aux Data of 1, investigate any EXP-INTF (Expansion Interface) errors.
Once the port’s circuit-pack location has been determined from Table 8-192, use
the list configuration all command to determine whether the circuit pack is
inserted. If the circuit pack has already been inserted but the error persists,
replace the circuit pack. If not, insert the pack.
Converting Aux Data to Port-Network Number
Aux Data Port-Network Number
01
12
23
34
45
56
67
78
89
910
10 11
11 12
12 13
13 14
14 15
15 16
16 17
17 18
18 19
19 20
20 21
21 22
To Next Page
Loading...
