Avaya S8700 - Page 1438

Maintenance-Object Repair Procedures
555-233-143
8-716 Issue 1 May 2002
Table 8-277. Test #795 Board Options Audit
Error
Code Test Result Description / Recommendation
105 ABORT The neighbor DS1 CONV circuit pack at the other end
of the DS1 CONV complex is not accessible (only
applies to TN574 boards with vintage less than 7).
1. Retry the command at 1-minute intervals up to 3
times.
2. The link to the other end of the DS1 CONV
complex may be down. Enter display errors and
follow the associated repair procedures for any
DS1C-BD and DS1-FAC errors.
2000 ABORT Timed out while waiting for a response from the circuit
pack.
2100 ABORT Could not allocate the necessary system resources to
run this test.
2300 ABORT The downlink message necessary to run this test could
not be sent.
2301 ABORT The timer could not be set before sending the downlink
message necessary to run this test.
1. Retry the command at 1-minute intervals up to 3
times.
2316 ABORT Fiber link is not administered. Administer the DS1
CONV fiber link via the add fiber-link command.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3
times.
PASS The options are sent to the circuit pack.
0 NO BOARD The system software found no board.
1. Reset the board.
2. Remotely retry the command.
Continued on next page