Maintenance-Object Repair Procedures
555-233-143
8-720 Issue 1 May 2002
Error Log Entries and Test to Clear Values
Notes:
a. There are two possible alarm levels for this error: Major alarm and Minor
alarm. A Major alarm is raised if the total number of DTMR ports currently
in service is less than or equal to 1/2 of the administered threshold number.
Otherwise, a Minor alarm is raised. In either case, run the short test
sequence against the DTMR port and follow the error code procedures for
the individual tests.
The threshold number of DTMR ports for service is administered using the
change system-parameters maintenance command.
b. The DTMR port lost its translation. Testing the DTMR port is sufficient to
reload its translation. If testing the DTMR port does not clear the error,
then the IPSI or Tone Detector circuit pack containing the defective DTMR
port should be replaced.
c. This error indicates the DTMR port is having problems detecting touch-tone
digits. If this error is being constantly logged, then the IPSI or Tone
Detector circuit pack containing the defective DTMR port should be
replaced.
d. This error type indicates that the circuit pack has been removed or has
been insane for at least 11 minutes. To clear the error, reinsert or replace
the circuit pack.
Table 8-279. Dual-Tone Multifrequency Receiver Port (TTR) Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test’s description, and follow its recommended procedures.
0 Any Any Any test port UUCSSpp sh r 1
1 17664 Tone Detector Audit/
Update test (#43)
MAJOR
MINOR (a)
ON test port UUCSSpp r 2
18 0 busyout port UUCSSpp WARNING ON release port UUCSSpp
130 (d) None WARNING ON test port UUCSSpp sh r 2
257 (b) 17666 Tone Detector Audit/
Update test (#43)
MAJOR
MINOR (a)
ON test port UUCSSpp r 3
513 (c) Any Tone Detection
Verification test (#42)
MAJOR
MINOR (a)
ON test port UUCSSpp r 3