Avaya S8700 - Page 1444

Maintenance-Object Repair Procedures
555-233-143
8-722 Issue 1 May 2002
Tone Detector Audit/Update Test (#43)
The DTMR port is refreshed with all time-slot information, and sanity audit is
performed on the DTMR port.
2100 ABORT Could not allocate the necessary system resources to run this test
1. Retry the command at 1-minute intervals up to 5 times.
2006 ABORT DTMF detection failed. Make sure that the companding mode administered for
the system matches that of the Tone Detector: mu-law for TN748, A-law for
TN420.
1-3 FAIL DTMF digits were not correctly detected.
1. Run the short test sequence: test port UUCSSpp sh r 1.
2. If the problem persists, the system is still operating properly but system
capacity will be reduced. In order to restore the system performance to
normal, replace the Tone Detector or IPSI circuit pack containing the
defective DTMR port.
PASS The DTMR port is able to detect every touch-tone digit.
Table 8-281. Test #43 Tone Detector Audit/Update Test
Error
Code
Tes t
Result Description / Recommendation
None ABORT The system was not able to allocate all the resources needed for this test.
1. Wait 1 minute and try again.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Hardware audit failed.
1. Run the short test sequence: test port UUCSSpp sh r 1.
2. If the problem persists, the system is still operating properly but system
capacity will be reduced. In order to restore the system performance to
normal, replace the Tone Detector or IPSI circuit pack containing the
defective DTMR port.
PASS The DTMR port has been successfully refreshed with its translation.
Continued on next page
Table 8-280. Test #42 Tone Detection Verification Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page